Time to fill up all those extra pins in the main ECM input connector.  By the time I am done here all 35 pins will be filled.  One big problem I ran into was after I had completed all the wiring I couldn't get the hood back on.  I kept looking up at the hood as I was adding all those wires but I mis-calculated how much space I had available.  I paid for that one. Took an hour or two to finally slide the top cover on.  Had to lay each wire so they didn't cross along with soaping the hood so it would slide easier.  There is no free space in there at all.  If something is miswired I will cut the harness outside the hood to fix it.  I was very close to the point of cutting some of the lower current signal lines, which were generally 18 gauge wire, and splicing in some smaller gauge wires in to the outside of the plug.  Those tie wraps up see aren't to keep the rubber on but to keep it from exploding......