Wiring from Amphenol Plug to rear ECM Compartment

     It was finally time to wire the Amphenol plug to the harness going to the rear ECM compartment.  Been really looking forward to this step because I knew soldering all those cables to that plug as going to be a real thrill.  I wasn't disappointed!  The existing wiring was just too short to reach the floor so all the soldering had to be done in mid air.  Glad it is done...  Hopeful the next portion of the harness going to the engine I can pull the wires up on top of the fender for a little easier access.

Stringing the newly required wires out the rear bulkhead.

This was the real fun part.  Basically had to solder all the wires on my stomach.  Getting too old for this.....

Finally all soldered and heat shrink in place.

Test fit.

Cabling all in place and tied down.

Fuel line heat shielding back in place.